(Ex:350-001):

1.Which configuration command removes all log filters currently configured on the ERX Edge Router?
A. no log here
B. no log fields
C. no log filters
D. no log severity
Answer: C

3. Which command is used to execute a macro called setup.mac
A. macro setup
B. macro setup.mac
C. run macro setup
D. run macro setup.mac
Answer: B

4. Log messages are appearing very quickly on the console of your ERX Edge Router. Which Privileged Exec command disables real-time console logging?
A. no log here
B. no log console
C. destination console severity 7
D. destination console logging off
Answer: A

5. Why would you make a non-backbone area a stub or not-so-stubby area?
A. to aggregate routes learned from the ABR
B. to lower the cost of routes advertised by the ABR
C. to connect a non-contiguous area to the backbone
D. to decrease the size of the link-state database in that area
Answer: D

6. What two BGP attributes are incorporated for loop prevention within an AS using a route reflection configuration? (Choose two.)
A. AS Path
B. Next Hop
C. Cluster List
D. Originator ID
E. Reflector List
Answer: CD

7. Your ERX Edge Router is constantly going to a boot## prompt. What is the most likely cause for this condition?
A. bad SRP
B. low voltage
C. bad mid-plane
D. corrupted flash
E. bad line module
Answer: D

8. In a Bridged 1483 network, which CLI commands are used to baseline an IP interface on ATM 6/1.1 and display recent IP transmit and receive statistics?
A. clear ip interface atm 6/1.1
show ip interface atm 6/1.1
B. baseline atm interface atm 6/1.1
show ip interface atm 6/1.1
C. clear ip interface atm 6/1.1
show ip interface atm 6/1.1 delta
D. baseline atm interface atm 6/1.1
show ip interface atm 6/1.1 delta
Answer: C


2. Which configuration command is used to make the ERX Edge Router an NTP server?
A. set ntp-server
B. set ntp server
C. ntp-server enable
D. ntp server enable
Answer: D